Gledhill StainlessLite Plus Direct Buffer Store 300 Litre Vented Cylinder – PLUDR300B
£516.67 EXCL. TAX
£620.00 INCL. TAX
These cylinders are sent direct from the manufacturer, normally within 14 to 21 working days. If the lead time is going to be significantly longer, we will contact you.
Buffer vessels are simply a duplex stainless steel tank that contains a volume of water, increasing the overall volume of the heating distribution system. This extra volume of water is designed to absorb any extra heat generated by the heat pump in low load conditions.
If the building cannot absorb the extra heat generated the return temperature to the heat pump will increase and will potentially cause the heat pump to turn off. If the temperature drops in the water returning to the heating appliance, then it will turn itself back on. If this cycling occurs at a greater frequency than the minimum run time for the appliance, this is classed as short cycling. The aim of a buffer vessel is to remove the possibility of any short cycling of the heating appliance.
These buffer vessels are designed to work at up to 3.5 bar pressure for primary water only. They should not be used for potable domestic hot water and are not approved for this purpose.
Features and Benefits
- Open vented duplex stainless steel cylinder in direct or indirect models
- Buffer stores increase the overall volume of the heating distribution system, and reduce the cycling of the heat pump
- Designed for use with either air source or ground source heat pumps
- Indirect models for use with gas or oil boilers, utilise a high efficiency corrugated coil to maximise heat transfer
- Lightest cylinder on the market.
- ErP rating: C
- Heat loss: 86 watts
- Capacity: 287 litres
- Height: 1990 mm
- Diameter: 550 mm
- Weight (empty): 39 kg
- Weight (full): 326 kg
Installation & Servicing Instructions: