Advance Appliances 140 Litre Vented Thermal Store Cylinder Direct Single Coil (TSDC 140)

Details

TSDC 140 Litre – These Advance Thermal Stores can be used with gas or oil boilers for the provision of fast, safe hot water provision throughout the house.

The direct pattern cylinder (TSDC) without the integrated feed and expansion tank has to be fed with a remote F and E tank sited above the highest point of the radiator circuit.

You need two pumps – one for the boiler to keep the store hot – controlled by the thermostat on the store, and one for the heating circuit  – controlled by the room thermostat and heating programmer.

Advance Appliances 140 Litre Vented Thermal Store Cylinder Specification

• 140 Litre
• Diameter: 600mm, Height: 1086mm
• Guaranteed for 10 years
• Fitted with Hot Water Control Pack
• Simple Technology – no PCB
• Direct Version offers buffering and fast heat up of radiators
• Indirect Version for Y plan and sealed system boilers
• Mains pressure hot water
• Safe open vented store

These low maintenance pre plumbed units provide flow rates up to 30 litres per minute and if linked to the appropriate gas, oil, or LPG boiler are suitable for average to larger properties. The bottom coil must be pumped.

They can be used to replace the Boilermate.

The units look smart too, with a wipe-clean appliance finish, and the insulation is 60mm foam injected for maximum efficiencies.

Stainless steel construction offers a lightweight long life product. The stores are guaranteed for ten years, the parts for two. They are made in the UK and meet the HWA Thermal Store Specification and Building Regulations

Downloads:

STANDARD THERMAL STORE DATA SHEET

STANDARD THERMAL STORE INSTALLATION GUIDE