Gledhill StainlessLite Plus Heat Pump Solar 180 Litre Unvented Cylinder – PLUHP180S

SKU: GH-D-343
Availability: In stock

Free shipping

£779.61 EXCL. TAX

£935.53 INCL. TAX


Customer Notice: These cylinders are sent direct from the manufacturer - please call us on 01691 888595 to confirm lead times

In stock

    Details

    *Delivery to Mainland UK Only – Delivery in 2-5 working days *
    Please Note Returns On This Item Will Incur A 25% Re-Stocking Fee And Must Be Returned At Your Cost via A Pallet Service With Insurance

    Gledhill have produced an unvented stainless steel unit specifically for heat pump applications providing mains pressure domestic hot water. Utilising the well established Gledhill StainlessLite Plus unvented hot water cylinder, this product has been developed to maximise the lower temperatures available from the heat pump.

    The heat exchanger is a totally new design. It consists of a multi-pass corrugated stainless steel tube in parallel to reduce the pressure loss whilst maximising the heat exchange. Many medium to large heat pumps need heat exchangers in the store that will cope with the higher flow rates associated with primary temperatures that are typically 50 or 60 degrees celsius.

    All the usual features of the Gledhill StainlessLite Plus are maintained together with all the necessary controls and expansion devices included.

    Due to the fact that many heat pumps will not raise the stored water temperature to 60 degrees celsius, which is necessary to prevent the growth of legionella, the StainlessLite Plus HP model is supplied with an immersion heater tapping and a thermostat pocket.

    It is recommended that a thermostat is fitted which brings the immersion heater on at a temperature just below the heat pump maximum and switches off at 60 or 65 degrees celsius. In this way the use of direct electricity is minimised and most of the water heating is achieved through the heat pump.

    Features and Benefits

    1. Designed for use with either air source or ground source heat pumps in addition to solar thermal panels
    2. High efficiency corrugated coil maximises heat transfer to the cylinder of water
    3. 3kW incoloy immersion heater for emergency back-up
    4. 90° elbow and drain valve supplied as standard
    5. Comes with a 25 year warranty
    6. Lightest cylinder on the market.

    Components With Product

    • Combination inlet group incorporating pressure reducing valve, strainer, check valve, balance cold take off point, expansion relief valve and expansion vessel connection points
    • Potable expansion vessels c/w integral wall bracket
    • Tundish
    • Drain elbow
    • Compression fittings
    • Dual control thermostat and combined overheat thermostat
    • Two port (28mm) zone valve for primary circuit
    • Technical/user product literature.

    Specification

    • ErP rating: B
    • Heat loss: 55 watts
    • Capacity: 178 litres
    • Height: 1306 mm
    • Diameter: 550 mm
    • Weight (empty): 33 kg
    • Weight (full): 211 kg
    • Surface area of HP coll: 1.36 m2
    • Dedicated solar volume: 63.5 litres
    • Number of immersions: 1
    • Secondary return: No

    Installation & Servicing Instructions:

    StainLess Lite Plus Heat Pump Manual

    Additional information

    Weight33 kg
    Brand

    Manufacturers Code

    PLUHP180S

    SKUGH-D-343